Custom Cutting Boarda Creation Story by Clark Wood Creations

Hi Joe,

I completed a sketch of your cutting board design illustrating the inlay and engraving. Please take a look and let me know if you have any questions or concerns. I'm planning to pick up the material this weekend and will keep you updated with the progress.

Thanks,
Lucas

• Bottom View
• Top View

Picked up some maple for your cutting board to go with the walnut I already had in stock. I'll start working on the cutting board this week.

The first step was to mill the maple and walnut to a consistent thickness and then rip many strips to create the edge grain board. In addition to the maple, a couple narrow strips were cut for the accent pieces.

Lots of glue and many clamps are used to glue up the board. It always looks messy at this stage!!

A couple trips through the drum sander to clean up the extra glue and burn marks and then trimmed to length at the table saw.

The maple inlay was glued into the board and then the name burned through the veneer to reveal the walnut below.

Just some detailed sanding left before the oil and wax.

• Laser Engraved
• Trim
• Sanding

Hi,

Here are a few photos of your completed cutting board all sealed and ready to be packed and shipped.

The engraving turned out really well!

Thanks,
Lucas

Hi,

Your cutting board was packed and shipped on Feb 21. You should be receiving it shortly.

It was great working with you on this project.

Thanks,
Lucas