Mark's Guitar Display Cases (3)

Display Cases were constructed from 3/4" Thick Birch Plywood. Door is constructed from 1" Thick x 2" Wide Solid Maple. All edges have a slight radius. Door Hinges are 1/2" diameter Hidden Barrel hinges. Outside dimensions of the Cases are 24" Wide x 48" Long x 11" Deep and the Interior is 9" deep. Back of Interior has a removable Black Felt covered panel. Back of Panel is recessed 3/8" for Hanging Cleat and uneven walls per customer request. The Finish is General Finished "EXPRESSO" Stain with Four coats of Satin Polyurethane applied.

Listed prices is per case.

View Shipping & Maker Policies

Made in Lebanon, PA

By Wooden-It-Be-Nice

All of our products are handmade
by expert makers.

  • Mark

    Mark's review

    • Apr 5th 2014

    The cases were completed ahead of schedule however, some things were changed such as the joint type (different joint used then proposed) and installation of silver latches versus the proposes brass (even though I accepted the silver after all.) The communication was a bit lacking but ended up ok in the end. The value does not meet the cost of the units in my opinion and they should have been $75 per case less and it would have been fine. I did not argue the price and paid in full the agreed to price but I feel I overpaid about $225 total.

    All in all the cases are acceptable and will be hung in my living room showcasing my prized guitars!

More Projects by Stephen Jornov

Other projects you might like

Also Appears In